Softub Hot Tub Pump, W/Thermal Wrap Heat Recovery Jacket (replaces pump with coil wrap)

Description

Motor:
Manufacture: Century / US Motors
Horsepower: 1 (1.5hp SPL) - Service Factor 1.0
Volts: 115/120
Amperage: 12
Speeds: Single
PRM: 3450
Frame: 48Y
HZ: 60
Stainless Steel Shaft

Pump:
Manufacture: AquaFlo/Gecko
1HP 1 1/2" Center Suction x Center Discharge - Fits Softubs with an AquaFlo FMCP series wet end

Note:
1 1/2" pump thread connections measure 2 7/16" outside diameter - FMCP
2" pump thread connections measure 3 1/16" outside diameter - XP2e

1 - Thermal Wrap Heat Recover Jacket: Pre-installed on pump motor
1 - Length 32" 3/8" ID Tubing
4 - Tubing clamps

Warranty: Lifetime - Thermal Wrap Heat Recovery Jacket
2 year motor manufacturers
1 year Balboa Controller

Please note that if you are replacing an AquaFLo XP2e series pump, we provide two pump thread adapters to accommodate 2" pump connections.
To ensure we include these adapters with your order, please mention this requirement at checkout or in a follow-up message.

If the pump and connections pictured do not match your current pump threads, please contact us to discuss your application requirements.

The replacement pump and motor with the Thermal Wrap serves as the primary heat source for many spa brands, including Quantum Spas, Dreammaker,FreeFlo, PDC, Softubs and others.

Even if your spa already includes an electric heater, the Thermal Wrap System provides a valuable complement by capturing waste heat generated by the pump motor and transferring it to the tub water. This process helps reduce overall heating costs and maintains water temperature during filtration cycles and high speed jet use.

More About The Thermal Wrap – Heat Recovery System:

New Design Offering Improved Performance and Structural Integrity:

Tub water circulates through a serpentine path in the Thermal Wrap, collecting the heat generated by the pump/motor and recycles that heat to the tub water – were it belongs!

Efficient:

– Patented design, over 1,000,000 Heat Jackets in use

– Special thermal conductive inner heat transfer liner

– Models available for most 48 frame thru bolt spa/hot tub and jetted bathtub pumps

Economical:

– Maintenance free – no moving parts to wear out

– Helps keep motor cooler – increases motor longevity and efficiency

– Cost less than electric heaters

– No additional electrical circuits required for installation

Safe:

– Manufactured of non-conductive materials

– Non electrical